USB CardReader wird nicht autmatisch gemountet

Antworten
Nachricht
Autor
Benutzeravatar
Triple666Blood
Beiträge: 25
Registriert: 02. Nov 2005 18:30

USB CardReader wird nicht autmatisch gemountet

#1 Beitrag von Triple666Blood » 11. Apr 2008 19:13

Hi,

habe mir einen CardReader zu gelegt. Dieser wird auch von ARCHLINUX erkannt.

dmesg;

---------------------------------------------------------------------------------------------------------

scsi 11:0:0:0: Direct-Access Myson SD/MMC/MS Reader 1.00 PQ: 0 ANSI: 0 CCS
sd 11:0:0:0: [sdc] 1935360 512-byte hardware sectors (991 MB)
sd 11:0:0:0: [sdc] Write Protect is off
sd 11:0:0:0: [sdc] Mode Sense: 03 00 00 00
sd 11:0:0:0: [sdc] Assuming drive cache: write through
sd 11:0:0:0: [sdc] 1935360 512-byte hardware sectors (991 MB)
sd 11:0:0:0: [sdc] Write Protect is off
sd 11:0:0:0: [sdc] Mode Sense: 03 00 00 00
sd 11:0:0:0: [sdc] Assuming drive cache: write through
sdc: sdc1
sd 11:0:0:0: [sdc] Attached SCSI removable disk
sd 11:0:0:0: Attached scsi generic sg3 type 0
usb-storage: device scan complete
usb 2-5: USB disconnect, address 6
usb 2-5: new high speed USB device using ehci_hcd and address 7
usb 2-5: configuration #1 chosen from 1 choice
scsi12 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 7
usb-storage: waiting for device to settle before scanning
scsi 12:0:0:0: Direct-Access Myson SD/MMC/MS Reader 1.00 PQ: 0 ANSI: 0 CCS
sd 12:0:0:0: [sdc] 1935360 512-byte hardware sectors (991 MB)
sd 12:0:0:0: [sdc] Write Protect is off
sd 12:0:0:0: [sdc] Mode Sense: 03 00 00 00
sd 12:0:0:0: [sdc] Assuming drive cache: write through
sd 12:0:0:0: [sdc] 1935360 512-byte hardware sectors (991 MB)
sd 12:0:0:0: [sdc] Write Protect is off
sd 12:0:0:0: [sdc] Mode Sense: 03 00 00 00
sd 12:0:0:0: [sdc] Assuming drive cache: write through
sdc: sdc1
sd 12:0:0:0: [sdc] Attached SCSI removable disk
sd 12:0:0:0: Attached scsi generic sg3 type 0
usb-storage: device scan complete
-----------------------------------------------------------------------------------------------------

Doch mountet er nicht automatisch mit HAL. Alle anderen Wechseldatenträger tun dies aber ohne Probleme. Also muss ich ihn immer manuell mounten.

Was kann ich nun tun, damit er automatisch mountet ?

Vielen Dank

MFG T6B

Antworten