habe ein problem mit meine Netzwerkkarte(cardbus).
beim einstecken in den entsprechenden slot beept´s einmal tief und folgende fehlermeldung erscheint auf dem screen:
" # cs: could not allocate 4K memory for CardBus socket 1 "
cardmgr und alles was dazugehört leuft auch (außer den realtek treiber)
OS: debian 2.2r3
netzwerkkarte: cardbus carte 10/100 Mbit/s(noname)
kernel:
2.2.19pre17
verschiedene ausgaben:
#lspci -vvv
00:00.0 Host bridge: Intel Corporation: Unknown device 7194 (rev 01)
Subsystem: Intel Corporation: Unknown device 7194
Control: I/O- Mem BusMaster SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort >SERR- <PERR
Latency: 32 set
00:00.1 Multimedia audio controller: Intel Corporation: Unknown device 7195
Subsystem: Unknown device 4144:5340
Control: I/O Mem- BusMaster SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0 set
Interrupt: pin B routed to IRQ 5
Region 0: I/O ports at d000
Region 1: I/O ports at d400
00:02.0 VGA compatible controller: Silicon Motion, Inc.: Unknown device 0710 (rev a3) (prog-if 00 [VGA])
Subsystem: Silicon Motion, Inc.: Unknown device 0710
Control: I/O Mem BusMaster SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap 66Mhz UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 set
Interrupt: pin A routed to IRQ 15
Region 0: Memory at e0000000 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 1
Flags: PMEClk- AuxPwr- DSI- D1 D2 PME-
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
00:03.0 CardBus bridge: O2 Micro, Inc. 6836 (rev 62)
Subsystem: O2 Micro, Inc.: Unknown device 6836
Control: I/O Mem BusMaster SpecCycle- MemWINV- VGASnoop- ParErr- Stepping SERR- FastB2B-
Status: Cap 66Mhz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 set
Interrupt: pin A routed to IRQ 11
Region 0: Memory at e1000000 (32-bit, non-prefetchable)
Bus: primary=00, secondary=20, subordinate=22, sec-latency=176
Memory window 0: 00000000-00000000
Memory window 1: 00000000-00000000
I/O window 0: 00000000-00000003
I/O window 1: 00000000-00000003
BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt PostWrite
16-bit legacy interface ports at 0087
00:03.1 CardBus bridge: O2 Micro, Inc. 6836 (rev 62)
Subsystem: O2 Micro, Inc.: Unknown device 6836
Control: I/O Mem BusMaster SpecCycle- MemWINV- VGASnoop- ParErr- Stepping SERR- FastB2B-
Status: Cap 66Mhz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 set
Interrupt: pin B routed to IRQ 11
Region 0: Memory at e1004000 (32-bit, non-prefetchable)
Bus: primary=00, secondary=23, subordinate=25, sec-latency=176
Memory window 0: 00000000-00000000
Memory window 1: 00000000-00000000
I/O window 0: 00000000-00000003
I/O window 1: 00000000-00000003
BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt PostWrite
16-bit legacy interface ports at 0087
00:07.0 ISA bridge: Intel Corporation: Unknown device 7198 (rev 01)
Control: I/O Mem BusMaster SpecCycle MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0 set
00:07.1 IDE interface: Intel Corporation: Unknown device 7199 (prog-if 80 [Master])
Control: I/O Mem- BusMaster SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 set
Region 4: I/O ports at f000
00:07.2 USB Controller: Intel Corporation: Unknown device 719a (prog-if 00 [UHCI])
Control: I/O Mem- BusMaster SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 set
Interrupt: pin D routed to IRQ 7
Region 4: I/O ports at e000
00:07.3 Bridge: Intel Corporation: Unknown device 719b
Control: I/O Mem BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
23:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RT8139 (rev 10)
Subsystem: Billionton Systems Inc: Unknown device 0200
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap 66Mhz- UDF- FastB2B ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 0
Region 0: I/O ports at <unassigned> [disabled]
Region 1: Memory at <ignored> (32-bit, non-prefetchable) [disabled]
Capabilities: [50] Power Management version 2
Flags: PMEClk- AuxPwr- DSI- D1 D2 PME-
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
#less /var/log/messages
Nov 7 21:04:40 laptop kernel: PCI_IDE: unknown IDE controller on PCI bus 00 device 39, VID=8086, DID=7199
Nov 7 21:04:40 laptop kernel: PCI_IDE: not 100%% native mode: will probe irqs later
Nov 7 21:04:40 laptop kernel: ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda: DMA, hdb: DMA
Nov 7 21:04:40 laptop kernel: ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc: pio, hdd: pio
Nov 7 21:04:40 laptop kernel: hda: TOSHIBA MK6015MAP, ATA DISK drive
Nov 7 21:04:40 laptop kernel: hdb: CD-224E, ATAPI CDROM drive
Nov 7 21:04:40 laptop kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Nov 7 21:04:40 laptop kernel: hda: TOSHIBA MK6015MAP, 5729MB w/0kB Cache, CHS=730/255/63
Nov 7 21:04:40 laptop kernel: hdb: ATAPI 24X CD-ROM drive, 128kB Cache
Nov 7 21:04:40 laptop kernel: Uniform CD-ROM driver Revision: 3.11
Nov 7 21:04:40 laptop kernel: Floppy drive(s): fd0 is 1.44M
Nov 7 21:04:40 laptop kernel: FDC 0 is a post-1991 82077
Nov 7 21:04:40 laptop kernel: md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
Nov 7 21:04:40 laptop kernel: scsi: <fdomain> Detection failed (no card)
Nov 7 21:04:40 laptop kernel: NCR53c406a: no available ports found
Nov 7 21:04:40 laptop kernel: sym53c416.c: Version 1.0.0
Nov 7 21:04:40 laptop kernel: Failed initialization of WD-7000 SCSI card!
Nov 7 21:04:40 laptop kernel: IBM MCA SCSI: Version 3.2
Nov 7 21:04:40 laptop kernel: IBM MCA SCSI: No Microchannel-bus present --> Aborting.
Nov 7 21:04:40 laptop kernel: This machine does not have any IBM MCA-bus
Nov 7 21:04:40 laptop kernel: or the MCA-Kernel-support is not enabled!
Nov 7 21:04:40 laptop kernel: megaraid: v1.11 (Aug 23, 2000)
Nov 7 21:04:40 laptop kernel: aec671x_detect:
Nov 7 21:04:40 laptop kernel: 3w-xxxx: tw_findcards(): No cards found.
Nov 7 21:04:40 laptop kernel: scsi : 0 hosts.
Nov 7 21:04:40 laptop kernel: scsi : detected total.
Nov 7 21:04:40 laptop kernel: Partition check:
Nov 7 21:04:40 laptop kernel: hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 >
Nov 7 21:04:40 laptop kernel: apm: BIOS version 1.2 Flags 0x07 (Driver version 1.13)
Nov 7 21:04:40 laptop kernel: apm: disabled on user request.
Nov 7 21:04:40 laptop kernel: VFS: Mounted root (ext2 filesystem) readonly.
Nov 7 21:04:40 laptop kernel: Freeing unused kernel memory: 156k freed
Nov 7 21:04:40 laptop kernel: NET4: Unix domain sockets 1.0 for Linux NET4.0.
Nov 7 21:04:40 laptop kernel: Adding Swap: 120452k swap-space (priority -1)
Nov 7 21:04:40 laptop kernel: Linux PCMCIA Card Services 3.1.22
Nov 7 21:04:40 laptop kernel: kernel build: 2.2.19pre17 unknown
Nov 7 21:04:40 laptop kernel: options: [pci] [cardbus] [apm]
Nov 7 21:04:40 laptop kernel: PCI routing table version 1.0 at 0xfdf00
Nov 7 21:04:40 laptop kernel: 00:03.0 -> irq 11
Nov 7 21:04:40 laptop kernel: 00:03.1 -> irq 11
Nov 7 21:04:40 laptop kernel: Intel PCIC probe:
Nov 7 21:04:40 laptop kernel: O2Micro OZ6836/60 rev 62 PCI-to-CardBus at slot 00:03, mem 0xe1000000
Nov 7 21:04:40 laptop kernel: host opts [0]: [ring] [pci/way] [pci irq 11] [lat 32/176] [bus 32/34]
Nov 7 21:04:40 laptop kernel: host opts <font size="1">: [ring] [pci/way] [pci irq 11] [lat 32/176] [bus 35/37]
Nov 7 21:04:40 laptop kernel: ISA irqs (default) = 3,4,9,10,12 PCI status changes
Nov 7 21:04:41 laptop kernel: cs: cb_alloc(bus 35): vendor 0x10ec, device 0x8139
Nov 7 21:04:41 laptop kernel: cs: could not allocate 4K memory for CardBus socket 1
Nov 7 21:13:19 laptop kernel: cs: cb_free(bus 35)
Nov 7 21:13:23 laptop kernel: cs: cb_alloc(bus 35): vendor 0x10ec, device 0x8139
Nov 7 21:13:23 laptop kernel: cs: could not allocate 4K memory for CardBus socket 1
Nov 7 21:24:40 laptop -- MARK --
habe auch mandrake 8.1 instaliert um zu schauen ob es da funzt,leider nicht fehlermeldung:unsupported card in socket 0
ich dachte das realtek karten unter linux problemlos laufen ist aber nicht so.
ich hoffe irgendjemand kennt sich mit der materie aus und kann mir helfen
mfg