Also hab mir ne neue NIC gekauft die wol fähig ist... leider braucht die NIC einen speziellen Treiber damit Wake On Lan funktioniert und zwar den rtl8139 (alle versuche mit wol und 8139too liefen schief).
Hier ist auch schon das Problem ich hab die rtl8139.c File und sollte das Ding kompilieren, leider stimmt der befehl der guide.txt (auf Diskette zur NIC + rtl8139.c) nicht bzw bricht ständig ab mit Fehlermeldung... In der Guide.txt steht ein Link zu einer Howto wie man den Treiber kompiliert jedoch gibts diese Page/URL was auch immer nicht.
Nun meine Frage... wie kann ich die rtl8139.c kompilieren so das ich sie verwenden kann für die NIC?
This document contains instructions on installing Linux driver
and adjusting speed for the series of RTL8139(A/B/C/8130) Network Adapter
Installing Driver:
(1.) Kernel Had Supported Driver:
Check the directory " /lib/modules/¡K./net " if you could find "rtl8139.o"
Your kernel had supported RTL8139 series. You could easy use "linuxconf"
to setup your card. If you don't like linuxconf, you also could use
"modprobe rtl8139" and "ifconfig up eth0" to load module.
If your driver load properly, your "/etc/conf.modules" should include
line of "alias eth0 rtl8139".
(2.) Kernel Don't Support Driver:
If your kernel doesn't support RTL8139 series, you should compiler driver
by yourself. Please contact http://www.scyld.com/network/rtl8139.html
to get source code. The compiler command is located on the end of source
code. Maybe like "gcc -DMODULE -Wall -Wstrict-prototypes -O6 -c rtl8139.c".
If you couldn't compiler success, maybe you should refer to error message
and copy library or head file to Linux.
Adjust Speed:
(1.) Adjusting speed:
Driver is designed with the gold that no options should be needed in most
environment. However not all cards and networks can be automatically
configured,thus allow operational parameters to be modify when they are
loaded as module. Typically the following variables may be set:
insmod rtl8139 options=0x40
Hex Decimal Meaning
0x10 16 ¡K..Force Full-Duplex operation (must be used with 0x20 or 0x40)
0x20 32 ¡K..Force 100mbps-only operation
0x40 64 ¡K..Force 10mbps-only
If loading as a module and configured /etc/conf.modules
alias eth0 rtl8139
options options=0x40