Mein neuer Speicherstick (Samsung 512 MB USB2) wird nicht richtig erkannt. Hier verschiedene Informationen:
Von "lsusb", das heißt, das Ding an sich wird erkannt:
Code: Select all
Bus 001 Device 002: ID 04e8:1623 Samsung Electronics Co., Ltd
Code: Select all
Nov 14 12:37:27 aldebaran kernel: hub.c: new USB device 00:07.3-1, assigned address 3
Nov 14 12:37:27 aldebaran kernel: scsi3 : SCSI emulation for USB Mass Storage devices
Code: Select all
Nov 14 12:30:16 aldebaran kernel: hub.c: new USB device 00:07.3-1, assigned address 2
Nov 14 12:30:16 aldebaran kernel: scsi2 : SCSI emulation for USB Mass Storage devices
Nov 14 12:30:16 aldebaran kernel: Vendor: Verbatim Model: USB Drive Rev: 2.00
Nov 14 12:30:16 aldebaran kernel: Type: Direct-Access ANSI SCSI revision: 02
Nov 14 12:30:16 aldebaran kernel: Attached scsi removable disk sde at scsi2, channel 0, id 0, lun 0
Nov 14 12:30:16 aldebaran kernel: SCSI device sde: 128000 512-byte hdwr sectors (66 MB)
Nov 14 12:30:16 aldebaran kernel: sde: Write Protect is off
Nov 14 12:30:16 aldebaran kernel: sde: sde1 sde2 sde3 sde4
Nov 14 12:30:16 aldebaran kernel: WARNING: USB Mass Storage data integrity not assured
Nov 14 12:30:16 aldebaran kernel: USB Mass Storage device found at 2
Code: Select all
Host: scsi3 Channel: 00 Id: 00 Lun: 00
Vendor: Model: Rev:
Type: <NULL> ANSI SCSI revision: ffffffff
Code: Select all
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=12 MxCh= 0
D: Ver= 2.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
P: Vendor=04e8 ProdID=1623 Rev= 1.00
C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=200mA
I: If#= 0 Alt= 0 #EPs= 3 Cls=08(stor.) Sub=06 Prot=50 Driver=(none)
E: Ad=81(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=83(I) Atr=03(Int.) MxPS= 64 Ivl=1ms
Schon 'mal vielen Dank!
Bodo