habe ein MicroLink USB Modem, was Linux SUSE 8.1) als Lucent Elsa Board erkannt hat.
Leider fkt. die Anwahl des Modems überhaupt nicht, sprich die Internetverbindung (exit Code
.Anbei das Prot. Vielleicht ist es ja nur eine
KLeinigkeit.
Vielen Dank im voraus.
Elkmen
Protokoll:
SuSE Meta pppd (smpppd), Version 0.78 on linux.
wwwoffle not is running
Selection of interface/provider "ppp0"/"Mobilcom" succeeded.
Reloading configuration.
Reloading interfaces and providers.
No interface configured. Use YaST2 to configure your dialup connections.
Selection of new provider "Compuserve Germany" failed.
Selection of new provider "Mobilcom" failed.
Selection of new provider "Compuserve Germany" failed.
Reloading configuration.
Reloading interfaces and providers.
Selection of interface/provider "ppp0"/"Compuserve Germany" succeeded.
Starting connection. (2002-10-20 09:26:10 CEST)
pppd: Plugin passwordfd.so loaded.
pppd: speed 1500000 not supported
pppd: --> WvDial: Internet dialer version 1.42
pppd: --> Initializing modem.
pppd: --> Sending: ATZ
pppd: --> Sending: ATQ0
pppd: ATQ0
pppd: OK
pppd: --> Re-Sending: ATZ
pppd: ATZ
pppd: OK
pppd: --> stdin not read/write and $MODEM not set
pppd: Connect script failed
pppd died: Connect script failed (exit code
Reloading configuration.
Reloading interfaces and providers.
Selection of interface/provider "ppp0"/"Compuserve Germany" succeeded.
Selection of new provider "Mobilcom" succeeded.
Starting connection. (2002-10-20 09:28:27 CEST)
pppd: Plugin passwordfd.so loaded.
pppd: speed 1500000 not supported
pppd: --> WvDial: Internet dialer version 1.42
pppd: --> Initializing modem.
pppd: --> Sending: ATZ
pppd: --> Sending: ATQ0
pppd: ATQ0
pppd: OK
pppd: --> Re-Sending: ATZ
pppd: ATZ
pppd: OK
pppd: --> stdin not read/write and $MODEM not set
pppd: Connect script failed
pppd died: Connect script failed (exit code