Optimierung?

Post Reply
Message
Author
Sebastian

Optimierung?

#1 Post by Sebastian »

Hallo!
Und zwar versucht mein suse 8.2 pro beim booten immer das zip laufwer (250MB parallel) zu mounten dies schlägt aber fehl weil keine disk drin ist: Hier ein auszug aus dem startprotokoll:
<6>parport0: Printer, Lexmark Lexmark Z42
<4>imm: Version 2.05 (for Linux 2.4.0)
<4>imm: Found device at ID 6, Attempting to use EPP 32 bit
<4>imm: Found device at ID 6, Attempting to use PS/2
<4>imm: Communication established at 0x378 with ID 6 using PS/2
<6>scsi1 : Iomega VPI2 (imm) interface
<4> Vendor: IOMEGA Model: ZIP 250 Rev: H.41
<4> Type: Direct-Access ANSI SCSI revision: 02
<4>Attached scsi removable disk sda at scsi1, channel 0, id 6, lun 0
<4>sda : READ CAPACITY failed.
<4>sda : status = 1, message = 00, host = 0, driver = 08
<4>Current sd00:00: sns = 70 2
<4>ASC=3a ASCQ= 0
<4>Raw sense data:0x70 0x00 0x02 0x00 0x00 0x00 0x00 0x12 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00 0x00 0x00 0xff 0xfe 0x01 0x00 0x00 0x00 0x00 0x00
<4>sda : block size assumed to be 512 bytes, disk size 1GB.
<6> sda: I/O error: dev 08:00, sector 0
<4>lost async page write due to I/O error on 08:00
<4>lost async page write due to I/O error on 08:00
<4>lost async page write due to I/O error on 08:00
<4>lost async page write due to I/O error on 08:00
<4>lost async page write due to I/O error on 08:00

Was kann ich dagenb tun, das das zip nicht automatisch gemountet werden soll?

Was ich noch fragen wolte:
Kann ich nach der installation noch irgendwas an der startgeschwindikeit tun?
Er brauch einige min um das sys zu laden

lenny

Re: Optimierung?

#2 Post by lenny »

Hi

Schau dir doch mal die fstab an,dort müsste dein ziplaufwerk aufgelistet sein,und nehm dann die Funktion "auto" raus.

ich hoffe das hilft.

gruss lenny

Post Reply