Hallo!
Ich möchte das gtk+ Packet auf meinem Rechner istallieren. Dazu brauche ich ja pango, glib und atk.
wenn ich jetzt glib compiliere, installiere und dann atk compilieren will sagt er:
checking for GLIB - version >= 2.0.0... no
*** Could not run GLIB test program, checking why...
*** The test program compiled, but did not run. This usually means
*** that the run-time linker is not finding GLIB or finding the wrong
*** version of GLIB. If it is not finding GLIB, you'll need to set your
*** LD_LIBRARY_PATH environment variable, or edit /etc/ld.so.conf to point
*** to the installed location Also, make sure you have run ldconfig if that
*** is required on your system
***
*** If you have an old version installed, it is best to remove it, although
*** you may also be able to get things to work by modifying LD_LIBRARY_PATH
configure: error:
*** GLIB 2.0.0 or better is required. The latest version of
*** GLIB is always available from ftp://ftp.gtk.org/.
Und wenn ich pango installieren will kommt:
config >= 1.0.1... Package fontconfig was not found in the pkg-config search path.
bash: ofchecking: command not found
gisela@linux:~/Documents/gtk/pamgo/pango-1.2.1> Perhaps you should add the directory containing `fontconfig.pc'
> to the PKG_CONFIG_PATH environment variable
> No package 'fontconfig' found
> checking for xft >= 2.0.0... Package xft was not found in the pkg-config search path.
> Perhaps you should add the directory containing `xft.pc'
> to the PKG_CONFIG_PATH environment variable
> No package 'xft' found
> configure: error: *** Didn't find any of FreeType, X11, or Win32.
Was kann ich da machen? (bin totaler newbie)
MfG Gerrit
pango
Re: pango
Hi!
1. Das hier kompilieren: http://nexp.cs.pdx.edu/fontconfig/relea ... 2_0.tar.gz
2. Glib: ftp://ftp.gimp.org/pub/gtk/v2.2/glib-2.2.1.tar.gz
3. Pango: ftp://ftp.gimp.org/pub/gtk/v2.2/pango-1.2.1.tar.gz
4. ATK: ftp://ftp.gimp.org/pub/gtk/v2.2/atk-1.2.0.tar.gz
5. zum Schluss Gtk: ftp://ftp.gimp.org/pub/gtk/v2.2/gtk+-2.2.1.tar.gz
Hoffe das hilft weiter!
c ya,
Tobias
1. Das hier kompilieren: http://nexp.cs.pdx.edu/fontconfig/relea ... 2_0.tar.gz
2. Glib: ftp://ftp.gimp.org/pub/gtk/v2.2/glib-2.2.1.tar.gz
3. Pango: ftp://ftp.gimp.org/pub/gtk/v2.2/pango-1.2.1.tar.gz
4. ATK: ftp://ftp.gimp.org/pub/gtk/v2.2/atk-1.2.0.tar.gz
5. zum Schluss Gtk: ftp://ftp.gimp.org/pub/gtk/v2.2/gtk+-2.2.1.tar.gz
Hoffe das hilft weiter!
c ya,
Tobias
Last edited by tkortkamp on 18. Feb 2003 22:06, edited 1 time in total.