wenn ich hdparm -iv /dev/hdd
eingebe kommt diese ausgabe:
werden bei UDMA modes die aufgelistet welche die platte hat??
[root@arno ~]# hdparm -iv /dev/hdd
/dev/hdd:
multcount = 16 (on)
IO_support = 0 (default 16-bit)
unmaskirq = 0 (off)
using_dma = 1 (on)
keepsettings = 0 (off)
readonly = 0 (off)
readahead = 256 (on)
geometry = 65535/16/63, sectors = 240121728, start = 0
Model=Maxtor 6Y120L0, FwRev=YAR41BW0, SerialNo=Y3NGA9ME
Config={ Fixed }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57
BuffType=DualPortCache, BuffSize=2048kB, MaxMultSect=16, MultSect=16
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=240121728
IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 *udma2 udma3 udma4 udma5 udma6
AdvancedPM=yes: disabled (255) WriteCache=enabled
Drive conforms to: (null):
* signifies the current active mode
weil wenn ich sie umstellen will mit
hdparm -X70 kommt zwar
aber wenn ich danach wieder hdparm -iv /dev/hddroot@arno ~]# hdparm -X70 /dev/hdd
/dev/hdd:
setting xfermode to 70 (UltraDMA mode6)
aufrufe ist das sternchen noch immer bei udma2
weiss jemand was ich da falsch mache?
oder warum es nicht gehen könnte?
vielen dank im voraus
mfg
arno